Skip to content

Cart

Your cart is empty

Continue shopping

KPOP2 collection

9.0 Base Curve Contacts

Compare contact lenses listed with 9.0mm base curve. Base curve (BC) is one part of the exact lens specification; keep it with the prescribed model and full diameter rather than using the number alone to select a substitute.

8 products

Sort by

LensTown Back to Basic Street Ash Brown — model portrait showing the contact lens look
LensTown Back to Basic Street Ocean Gray — model portrait showing the contact lens look
LensTown Back to Basic Street Ash Beige — model portrait showing the contact lens look
LensTown Back to Basic Street Ash Pink — model portrait showing the contact lens look
LensTown Back to Basic Macaron Gray — single-eye close-up showing the contact lens appearance
LensTown Back to Basic Macaron Brown — model portrait showing the contact lens look
LensTown Back to Basic Macaron Pink — model portrait showing the contact lens look
Back to Basic Macaron Violet 14.2mm

9.0 Base Curve Contacts — Buying guide

Compare BC with the complete model

Two lenses can share a base-curve number while differing in material, full diameter, design and prescription options. A matching BC alone does not establish interchangeability.

Read the exact listed value

A range in a collection title groups listed values; it is not a continuously adjustable curve. If a product offers multiple values, confirm the exact available configuration for that model.

Continue with the correct replacement version

Check whether the model is daily or reusable and read its individual lens count. Match the complete prescription and available order selectors before checkout.

Shop Contact Lenses by Base Curve · By Graphic Diameter

Questions about this collection

Can I choose any lens listed with 9.0mm base curve?

No. Use the exact prescribed model and complete fit parameters. The base curve alone is not enough to choose a different contact lens.

Is BC the same as DIA or graphic diameter?

No. BC is base curve, DIA is full lens diameter and graphic diameter describes the printed design area. Check them as separate specifications.